The powder -shaped filling machine is a semi -automatic filling machine, and the supporting facilities are automatically applied. The metering and test method of the filling machine uses the squeezing machine screw rotating turns to measure the net weight of the raw material; the filling machine automatically submits the supporting facility spiral material according to the material sensor.

        1. The filling method of the filling machine is selected in both manual and automatic methods; in the case of equipment applications, both manual and automatic methods must open the vibration (mixing and) method of the handbar. When the device runs the feeding, the raw material in the barrel body produces cracks, resulting in uneven net weight.

        2. Time setting of vibration (mixing and) method, according to the time of specific feeding. For example: filled 450 grams of original materials, from the feeding of the feeding mouth, to the thorough to the packaging bag, it must be 3 seconds; then the time of the vibration (mixing) method is preset of 3.5 seconds. When other net weight is filled, the presetting time is 0.5 seconds longer than the feeding time.

        3. If the device is set to an automatic filling method, the automatic time of the panel on the hand panel refers time.

        4. Setting of the net weight of the filling: The net weight of the filling is to adjust the number of turns; how much is the proportion of the net weight of the raw materials; When the amount of irrigation is changed to 400 grams, it is necessary to adjust the label value to be reduced to a suitable situation.

        5. The power consumption of the spiral upper feeder must be obtained from the filling machine; it is forbidden to immediately connect to other switching power supply! The spiral feed machine itself has the function of automatic feeding, automatic feeding and its overvoltage protection;

        6. When the spiral feed machine is automatically applied, when the powder arrives at the material, the feed opportunity will be terminated automatically; when the powder is smaller than the material sensor, the feed opportunity will be automatically applied for about 10 seconds; everything is manufactured normally; This role will be circulating system at the time;

        7. If the pink raw material is in the middle, mixed and dirt, wire frames, etc., resulting in the obstruction of the feed machine. The load is turned on due to the increase in load. At this time To turn off the total switching power, finish mixed and dirt in the powder raw material, and then restart the material machine;

        When the filling machine terminates the production and manufacturing, when the powder is necessary in the pipeline in the spiral pipeline, the power switch of the feeder must rotate to Feeding, and then turn on the inlet under the feeder and start the feeding!