How to get started with liquid filling machine

        1. Before the installation machine work, we must take the excellent grounding device on the ground line, and then select the suitable standard injection needle according to different bulk volume

        2. Pluck the injection needle shell out and put the snail danger on the injection needle shell.

        3. Put the upper tube hoop seat at the end of the drainage of the injection needle coat, and tighten the nuts on both sides.

        4. Integrate the installed injection needle shell and coat, and the installation of the software injection system is over.

        5. Put the arrow symbol of the gate valve, and the arrow symbol logo is fixed on the external nut and does not move on the fixed screw.

        6. Install the detailed liquid injection system software, and fix the liquid injection system software components, lower circular caves, each fix the upper, lower fixed rods, and put it on the rolling bearings, and make the other inner holes and rolling bearing faces flat. When installing below, do not collide with the thread cover and the gear to prevent the sound sound of an abnormal sound when the upper gear rotates. After the liquid injection system software is properly installed, the upper and lower fixing screws are tightened. Use a short rubber hose to connect the injection needle with the gate valve. The leakage pipe is connected to the water pipe, and the drainage pipe road is connected to the drainage port. In order to avoid the in -in -and -out pipes around, the in -out liquid pipe is hoop into the inside of the mouth of the mouth of the outer shell.